Stop knot

A movable depth stop for a sliding float

Also known as
float stop, power gum stop, sliding stop knot
Difficulty
Easy
Relative strength
Medium
Lines
Mono, Copolymer
Use it for
Float stop

Step by step

  1. Lay the gum alongside

    Cut about 15cm of power gum, or 30cm of spare mainline, and lay it along the mainline where the float should stop.

  2. Form a loop

    Bring one end down and back to make an open loop under the line.

  3. Turns through the loop

    Wrap the gum around the mainline and itself inside the loop four or five times.

  4. Tighten and trim

    Wet the knot and pull both ends tight. Slide it to depth and trim both tags to about 2.5cm.

What goes wrong

  • Tied so tight it cannot slide. It should move with a firm pinch.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs