Spade end (by hand)

The same whipping with no tool: bank repairs

Difficulty
Hard
Relative strength
High
Lines
Mono, Copolymer
Use it for
Hook

Step by step

  1. Lay a loop along the shank

    Hold the hook by the bend. Lay the line along the shank and double it back into a long loop below.

  2. Whip over shank and loop

    Wrap eight to ten turns around the shank and both legs of the loop, working toward the bend. Grip each turn under your thumb.

  3. Tag through the loop

    Push the tag end through what is left of the loop.

  4. Draw it under and check

    Wet it. Pull the standing line so the loop drags the tag under the wraps, slide the knot up to the spade and check the line leaves the inside of the spade. The hook tyer version is easier below size 18.

What goes wrong

  • Turns bunching over each other instead of lying in a row.
  • Losing the loop tension halfway loses the whole whipping.
  • Line leaving the outside of the spade. It must leave the inside, the side the point faces, or the spade cuts it.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs