Spade end (hook tyer)

Hooklength to a spade-end hook, with the tool

Also known as
whipping knot
Difficulty
Easy
Relative strength
High
Lines
Mono, Copolymer
Use it for
Hook

Step by step

  1. Clamp the hook

    Grip the hook by the bend in the tyer jaws, spade pointing out. The tool holds it still so fine line stays kink-free.

  2. Lay the line and wind

    Lay the line along the shank and wind ten to fourteen neat turns in the direction your tool’s instructions give.

  3. Catch the tag and pull through

    Hook the tag into the tyer’s catch and pull it so the last, largest loop closes down on the turns.

  4. Slide to the spade and check

    Push the whipping up against the spade and pull tight. The line must leave the inside of the spade, the side the point faces, or the spade cuts it on a fish.

What goes wrong

  • Line leaving the outside of the spade cuts itself under load. It must leave the inside, the side the point faces.
  • Fewer than ten turns. Drennan gives ten to fourteen.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs