Quick-change bead

Swaps hooklinks in seconds on a method feeder or running ledger

Also known as
quick change bead, QC bead, hooklink bead
Difficulty
Easy
Use it for
Swivel

Step by step

  1. Two parts

    A quick-change bead comes in two parts. The bead body has a swivel on top and a quick-change hook below. The tail rubber is a separate sleeve.

  2. Thread the feeder

    Run the mainline through an inline method feeder, in at the top and out of the socket in its base. Leave 20cm hanging below to tie with.

  3. Half blood knot to the swivel

    Pass the mainline through the swivel on top of the bead body and tie a half blood knot. Wet the turns and bed the knot down slowly against the swivel eye. Trim the tag close, leaving 2-3mm.

  4. Seat the bead in the feeder

    Pull the mainline back up and push the bead into the base of the feeder until it seats. The feeder now fishes semi-fixed, and it pulls free of the bead if the mainline breaks.

  5. Tail rubber onto the hook

    Push the tail rubber onto the hook of the bead and slide it up against the bead body, so the bend is bare.

  6. Loop the hooklink on

    Drop the loop of a pre-tied hooklink over the hook of the bead and pull it down into the bend.

  7. Sleeve the rubber back over

    Slide the tail rubber down over the hook and the loop. The rubber locks the loop on, so the hooklink cannot jump off.

  8. Swap in seconds

    To change, push the rubber up, lift the loop off and drop the next hooklink on. Hooklinks tied to the same length keep the rig the same every time.

What goes wrong

  • Bead not pushed into the feeder until it seats. The feeder flies off on the cast.
  • Tail rubber not sleeved back over the hook of the bead. The loop flicks off on the cast or in the fight.
  • Hooklink loop too thick for the hook of the bead. Tie a small figure-of-eight loop so the rubber slides down over it.
  • Blood knot not bedded down. Wet the turns and pull it tight before the first cast.
  • Tag trimmed flush against the turns. Leave 2-3mm so the knot cannot pull through.

In the Tightlog app this rig animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs