Predator float rig

Deadbait float rig for pike and zander

Difficulty
Moderate

Step by step

  1. Float stop and sliding float

    Slide a float stop onto the mainline, then thread on the sliding float.

  2. Weight, bead and swivel

    Slide on an inline weight a little lighter than the float rating, then a soft plastic bead, and tie the mainline to the swivel with a half blood knot.

  3. Metal trace and trebles

    Cut about 40cm of metal trace. Fix one treble at the end, a second treble set apart to cover the bait evenly, and a swivel at the other end.

  4. Mount the deadbait

    Put the barbed hook of each treble into the deadbait. Set the float slightly over depth so a bite drags it along the surface.

What goes wrong

  • Mainline tied straight to the hooks. Use a metal pike trace between the swivel and the hooks.
  • Float set too short. Set it slightly over depth when you fish a deadbait.
  • Every treble hook barbed. Remove the barbs from two hooks on each treble.

In the Tightlog app this rig animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs