Palomar

Braid-safe knot for hooks and drop shot

Difficulty
Easy
Relative strength
High
Lines
Braid, Mono, Fluorocarbon
Use it for
Hook, Swivel

Step by step

  1. Double and thread

    Double about 15cm of line and push the loop end through the eye.

  2. Loose overhand

    Tie a loose overhand knot with the doubled line, so the hook hangs from the bottom of it. Do not tighten it yet.

  3. Hook through the loop

    Open the loop end and pass the whole hook through it, so the loop goes over the shank and behind the point.

  4. Pull the knot tight

    Wet the knot. Pull the standing line and the tag together so the loop rides over the eye and the knot beds down above it.

  5. Trim the tag

    Trim the tag, leaving about 6mm.

What goes wrong

  • The loop must pass over the whole hook, not just the bend.
  • A twist in the doubled line costs most of the strength.
  • Strands allowed to cross as the knot beds down.
  • Knot bedded down around the shank. All of it must tighten above the eye.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs