Method feeder rig

Inline feeder rig for small to medium carp

Also known as
inline feeder rig
Difficulty
Easy

Step by step

  1. Thread the feeder

    Take the spare swivel out of the inline feeder and thread the mainline through it.

  2. Tie on the swivel

    Tie the swivel to the mainline with a half blood knot, wet it and pull it tight.

  3. Pull the swivel into the feeder

    Slide the feeder down until the swivel seats neatly in the insert.

  4. Tie a short hooklength

    Tie the hook on three to five inches of hooklength, wrapping the line about seven times and passing it back through the eye towards the point.

  5. Loop it onto the swivel

    Tie a figure-eight loop in the other end, pass it through the swivel eye and pass the hook through the loop.

  6. Mount the hookbait

    Hair-rig the bait on a speed stop, or stretch a band around a hard pellet.

  7. Press the feed on

    Squeeze the feed over the ribs and press the hookbait into it, so everything leaves the feeder together.

What goes wrong

  • Swivel left outside the feeder. Pull it into the insert so it seats.
  • Hooklength too long. Three to five inches works, and many fisheries set a minimum, often about four inches.
  • Half blood pulled tight dry. Wet the knot first.

In the Tightlog app this rig animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs