Knotless knot

Hair rig on an eyed hook

Also known as
hair rig knot
Difficulty
Moderate
Relative strength
High
Lines
Mono, Copolymer, Fluorocarbon, Braid
Use it for
Hair rig, Hook

Step by step

  1. Tie the hair loop

    Tie a small loop in the end of the hooklength. This loop will hold the bait stop.

  2. Thread the eye

    Pass the other end through the eye towards the point, so the hair leaves the eye on the side away from the point.

  3. Set the hair length

    Pull the line until the loop sits just below the bend. This gap sets where the bait rides.

  4. Whip down the shank

    Lay the hair along the shank and wrap the line around the shank and the hair about seven times, or about ten with coated braid, working from the eye toward the bend. Stop a few mm above the point. Keep the turns touching.

  5. Back through the eye

    Pass the end of the line back through the eye, in the same direction as the first pass, towards the point.

  6. Bed down and check

    Moisten and pull tight. Check the hair leaves the shank opposite the point, then test with a firm pull.

What goes wrong

  • Hair set the wrong length. Measure it against the bait first.
  • Uneven whipping that bunches instead of lying in a row down the shank.
  • Line fed through the eye from the outside, which turns the point away.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs