Hair rig

The standard bottom-bait carp rig

Difficulty
Moderate

Step by step

  1. Tie the hair loop

    Strip about 3in of coating from the hooklink, tie an overhand loop, and lock the bait on the loop with a bait stop.

  2. Tie the knotless knot

    Pass the hooklink through the eye towards the point, wrap it round the shank 7 to 10 times, then pass it back through the eye towards the point.

  3. Join the hooklink

    Tie an overhand loop in the other end of the hooklink and pass it over the crook of a quick change swivel.

  4. Fit the lead clip

    Tie the mainline to the swivel with a half blood knot, pull the swivel into the clip until it clicks, hang the lead on the clip, then push the tail rubber on gently.

  5. Add the tubing

    Slide the anti-tangle tubing down so it sits in the end of the tail rubber.

What goes wrong

  • Knots not wetted before they are pulled tight. Friction damages mono and fluorocarbon.
  • Tail rubber pushed on very hard. In a bad snag the lead may not come off.

In the Tightlog app this rig animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs