Grinner

Ties line to an eyed hook or swivel

Also known as
uni knot
Difficulty
Easy
Relative strength
High
Lines
Mono, Copolymer, Fluorocarbon, Braid
Use it for
Hook, Swivel

Step by step

  1. Thread the eye

    Pass about 10cm through the eye and lay the tag back along the standing line.

  2. Form the loop

    Bring the tag back toward the eye in an open loop below the two strands.

  3. Five turns through the loop

    Wrap the tag around both strands inside the loop five times. Use fewer on thick line and more on fine line.

  4. Close the coils

    Wet the knot, then pull the tag so the coils close into a neat spiral.

  5. Slide down to the eye

    Pull the standing line so the knot slides down onto the eye. Trim the tag to 2-3mm.

What goes wrong

  • Too few turns. Tie five, and add a turn or two on fine or slippery line.
  • Closing the loop before wetting the turns.
  • Trimming the tag before the knot has been slid down to the eye.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs