Full blood knot

Joins two lines of similar thickness

Also known as
blood knot, barrel knot
Difficulty
Moderate
Relative strength
Medium
Lines
Mono, Copolymer, Fluorocarbon
Use it for
Line to line

Step by step

  1. Overlap the lines

    Lay the two ends over each other by 6-8cm, with the tags pointing opposite ways.

  2. Wrap the first tag

    Wrap the first tag around the other line five to seven times, working away from the middle.

  3. Tuck the first tag

    Bring the tag back to the middle and pass it through the gap between the two lines.

  4. Wrap the second tag

    Wrap the second tag around the first line the same number of times, away from the middle on the other side.

  5. Tuck the second tag

    Pass the second tag through the same gap, in the opposite direction to the first tag.

  6. Wet and pull tight

    Wet the knot, pull the two standing lines apart slowly so the turns bed down, then trim both tags close.

What goes wrong

  • Fewer than five turns on each side. Use five to seven.
  • Pulled tight dry. Wet the turns first.
  • Both tags tucked the same way. They must pass through the centre in opposite directions.
  • Tags trimmed before the turns have bedded in.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs