Float rig

Waggler setup for still water

Also known as
waggler rig, shotting pattern
Difficulty
Easy

Step by step

  1. Thread the float

    Run the mainline through the bottom eye of the waggler, which attaches at the bottom only.

  2. Loop on the hooklength

    Join a lighter hooklength to a loop in the mainline, loop-to-loop, so you can change it in seconds.

  3. Lock the float with shot

    Pinch shot either side of the float so they carry most of the weight and hold it in place.

  4. Spread the small shot

    Space the remaining No.4 shot evenly down the line for a slow, natural fall.

  5. Optional: bulk the shot

    To reach the bottom faster, group the shot into a bulk near the hook and add one small tell-tale shot below it.

What goes wrong

  • Depth never plumbed. Find the depth before the first cast.
  • Too much shot. A well shotted float shows only a centimetre or two of tip.
  • Shot bunched when the fish feed high. Strung-out shot gives the slow, natural fall.
  • Knots pulled tight dry. Wet each knot first.

In the Tightlog app this rig animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs