Double grinner

Joins two lines, even of different thickness

Also known as
double uni
Difficulty
Moderate
Relative strength
High
Lines
Mono, Copolymer, Fluorocarbon, Braid
Use it for
Line to line

Step by step

  1. Overlap the lines

    Lay the two ends side by side with a good 15cm of overlap.

  2. Loop the first line

    Bring the first tag back over both lines in an open loop, as for a normal grinner.

  3. Four turns through the loop

    Wrap the tag around both lines inside the loop four times on mono or fluorocarbon, and eight times on braid.

  4. Close the first grinner

    Wet the knot, then pull the tag so the coils close around the other line.

  5. Loop the second line

    Turn the work round. Bring the second tag back over both lines in an open loop.

  6. Four turns for the second grinner

    Wrap the second tag around both lines inside its loop, with the same number of turns. Wet it and pull it closed.

  7. Close the second grinner

    Pull the second tag so its coils close around the first line.

  8. Slide them together

    Pull the two standing lines so the knots slide together and seat against each other. Trim both tags to 2-3mm.

What goes wrong

  • Each grinner must be bedded down on its own before the two are pulled together.
  • Unequal turns. Give the thinner line the extra turn.
  • Tags cut flush before the knots have seated slip under shock.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs