Arbor knot

Ties line to the reel spool

Difficulty
Easy
Relative strength
Low
Lines
Mono, Copolymer
Use it for
Spool

Step by step

  1. Round the spool

    Pass the end of the line around the spool, with the bail arm open.

  2. Tie round the standing line

    Tie an overhand knot with the tag around the standing line. Leave it loose.

  3. Add a stopper

    Tie a second overhand in the tag end alone, a few centimetres from the first knot.

  4. Pull snug

    Wet the knots. Pull the standing line so the first knot slides down to the spool and the stopper jams against it. Trim close.

What goes wrong

  • Braid tied straight to the spool spins. Put mono backing or tape under it.
  • Stopper knot left too small to bite against the main knot.
  • Line slips on a smooth spool. Take the line round the spool two or three times before the first overhand.

In the Tightlog app this knot animates step by step - scrub through it with a thumb, on the bank, with no signal.

Download

All knots and rigs